Meridian America DSP5000 User Manual download pdf (Page 14)

Using DSP5000 14

DSP5000 User Guide

Basic operation of DSP5000

Note DSP5000 is factory set for the most common installation, one using

the full features of a Meridian 500-Series CD player and 562 controller.

We call this a Type 1 installation. For more details, see Appendix 1 on

page 55.

Selecting sources

To switch from CD to another input, say Radio:

1. Press Radio

In Type 1, this will select RD on a Meridian 562.

Both DSP5000s display

rd 65

Here rd means that the source is a radio tuner, and that the DSP5000

expects a Meridian 504 to be connected to the Radio input of the 562 and

into the communications system. The 504 can now be controlled by the

MSR, and its status can be displayed on the master DSP5000. 65 is the

volume number.

The other input keys on the MSR (e.g. LP, Tape 1, Video and Tape 2)

operate in a similar way in Type 1:

The LP input of a Meridian 562 is engaged. The D1 input of the DSP5000

is selected. The display shows

LP 65

The Tape 1 input of a Meridian 562 is engaged. The D1 input of the

DSP5000 is selected. The display shows

t1 65

Note These responses are for DSP5000s set up for Type 1, and can be

changed. See later.

Selecting a source will bring DSP5000 out of Standby.

Note If you have stored a preferred tone setting for a source, you must

recall it after switching to the source; recall settings by pressing Store.

Putting the DSP5000 in Standby

1. Press Off on the remote control

Coming out of Standby

To start up the DSP5000 from Standby:

1. Select a source, using the remote control

1. If the DSP5000 is part of a Meridian

system, bring any component out

of Standby (for example, start up a Meridian CD player).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 65 66

No comments

Meridian America DSP5000 User Manual Page 14