Meridian America 598 User Manual download pdf (Page 19)

Using the DVD player

Switching on and off

When not playing, the DVD player should be left in the standby

state. This uses a minimal amount of electricity, but ensures that

the components of the DVD player operate at maximum

efficiency from the moment you start.

After switching on the 598 runs an initialising cycle which takes a

few seconds. Do not press any keys until the standby display

appears.

If you are not going to use the DVD player for several days you

should switch the unit off completely at the rear panel, and

disconnect it from the AC power supply.

To switch on from standby

● Press Open, *, or > (front panel), or select a source on the

remote.

If the DVD player is part of a Meridian system it will automatically

switch on any other unit in the system, such as the 568 Digital

Surround Processor and Meridian DSP Loudspeakers.

To switch to standby

● Press Off (front panel or remote).

The display will show:

If you have other Meridian 500 Series equipment connected to

the DVD player, these units will also switch to standby.

If a disc is currently playing, switching to standby will stop the

disc, and the disc can safely be left in the unit.

Always remove any discs before moving or shipping the 598.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 86 87

No comments

Meridian America 598 User Manual Page 19